Electrolux EWF1141AEWA User Manual page 32

32 www.electrolux.com
Malfunction
Machine
vibrates or
is noisy:
Cycle time
longer than
displayed:
The cycle is
shorter than
the time
displayed.
Spinning
starts late
or machine
does not
spin:
Machine
makes an
unusual
noise:
No water is
visible in
the drum:
Remote
function
does not
work:
Possible cause
The laundry is not evenly distributed in
the drum.
There is very little laundry in the drum.
Unstable floors eg. wooden floors.
Detergent over dose.
Machine unbalance.
The appliance calculated a new time according to the laundry
load.
The electronic unbalance detection
device has cut in because the laundry
is not evenly distributed in the drum.
The laundry is redistributed by
reverse rotation of the drum.
This may happen several times
before the unbalance disappears and
normal spinning can resume. If, after
10 minutes, the laundry is still not
evenly distributed in the drum, the
machine will not spin. In this case,
redistribute the load manually and
select the spin program.
Machine not installed properly.
Transit bolts or packaging not
removed.
The load may be too small.
Machines based on modern technology operate very economically
using very little water without affecting performance.
Registration Data lost or damaged.
(Error Code: )
Solution
Pause the machine and
redistribute laundry manually.
Load more laundry.
Refer to relevant paragraph
in "Positioning" section.
Reduce the detergent
quantity or use another one.
(Refer page 23 "Detergents
Type And Quantity Of
Detergent").
Redistribute laundry
manually in the drum and
start the spin phase again.
Pause the machine and
redistribute laundry
manually.
Make sure the levelling of
the appliance is correct.
Refer to "Installation".
Make sure that the
packaging and/or the transit
bolts are removed. Refer to
"Unpacking".
Add more laundry in the
drum.
Restart machine by turn Off
and turn On again. If problem
not solved, please contact
Service Centre.