Advertisement
Preparing the Lancing Device
1
Remove the cap
1
Turn the cap of the lancing device counter-clockwise to remove the cap.
Insert a Lancet into the Lancet Holder.
Insert the lancet firmly into the holder until it comes to a full stop. When the
lancet is placed in the lancing device, twist off the protective disk of the lancet.
Do not discard the protective disk of the lancet; it will be used to dispose the
lancet safely after its use.
Replace the cap
Turn the cap of lancing device clockwise until it fits.
- Before using the lancing device, wash your hands in warm water with soap.
Make sure to rinse and dry them thoroughly. Perspiration, dirt or water
remaining on your hands may cause incorrect test results.
- Avoid using hand lotion or any other oily products before using the lancing
device.
Advertisement
