Advertisement
1
- Do not drink the control solution.
- Tightly close the cap of control solution vial and store at a room temperature
after the test.
Insert a Test Strip
1
Insert a test strip, with the printed side facing up, into the test port of the meter.
Gently push it all the way in until it goes no further.
The meter will turn on automatically and beep. Then the code number and the
BLOOD DROP ICON will appear. Make sure that the code number displayed on
the meter matches the one on the test strip vial. If the code numbers match,
you can start the test. If the code number on the meter doesn't match the one
on the test strip vial, adjust the code number on your meter. (see page 6-8)
Do not force the test strip into your meter.
This may cause malfunction.
Advertisement
