Default Settings (With Factory Mode) - NEC DPro2070SB Service Manual

2.4.9

Default settings (With factory mode)

Adjustment item
Status
Default settings
indicator
(1) Set the default values as shown in the table (user mode) given in OSM display (Refer to
2.3.2.1 User mode).
If the setting class is an item with each timing, carry out with each adjustment timing.
(2) Return to the user mode with the front panel.
(3) Execute FACTORY PRESET to confirm that each OSM setting is as shown in the table
(user mode) given in OSM display (Refer to 2.3.2.1 User mode).
Only CONTRAST will be set to 100% when RESET button is pressed in the normal mode.
(4) How to set OSM BRIGHTNESS RESET value (30.1%) in user mode.
(a) Change to FACTORY MODE in advance.
(b) Set the counter of FACT DATA on OSM to 99 using (-) (+) buttons, and push SELECT
button.
(c) Using ( ) (
(d) Using (-) (+) buttons set DATA to 04D.
(e) Press EXIT button to record 04D set in (d) mentioned above.
(f) To disable this rewriting function, turn the power OFF (FACTORY MODE is still alive
even if the power was turned OFF).
Return to USER MODE.
Select BRIGHTNESS with OSM, and press RESET button, then the data (04D = 30.1%) set in
(d) mentioned above is called.
(For your information; when (-) and (+) buttons are pressed simultaneously, the data is set to
50%.)
(5) After setting the default values, turn the power button OFF.
Adjustment mode/set
Factory mode
) buttons to set ADDR to 0B1.
2 - 23
Imput signal/pattern
Each adjustment timing