Table of Contents
Advertisement
Correct Usage
When you use the air conditioner for the first time or change the settings, follow the procedures below.
From the next time, pressing the ON/OFF button will run the air conditioner with the chosen settings.
Turn on the circuit breaker and leakage breaker
When turned on, the separation line
●
appears and
remote control display.
* The remote control will not work for
about one minute after turning on the
power. This is not a malfunction.
Operations
1
Push the
button to start operation
● The operation lamp lights up.
2
Push the
to select a running mode
● Each time you push the button, the running mode and its
indication change in the following order:
Heating
3
Push the
operation
● The operation lamp turns off.
Changing the Temperature Setting
Push
● Push
to increase the temperature, and
decrease the temperature. (The temperature setting cannot
be changed in the FAN mode.)
Note
When cooling
Running starts in approximately one minute.
●
When heating
The air conditioner may continue running in the FAN mode for about 30 seconds after stopping heating.
●
While preheating takes place the indoor fan will not move for 3-5 minutes. It will start working when the preheating
●
is finished. (The pre-heat indicator is displayed on the remote control)
The air volume becomes extremely low when the room temperature has reached the set temperature. However,
●
for floor types (direct type, duct type), the air volume does not change after room temperature has reached the set
temperature.
7
blinks on the
button
Cooling
Fan
button to stop
to select the temperature
Note
Keep the breaker turned on during use.
●
When you resume using the air conditioner
●
after a long period of disuse, turn the power
switch on at least 12 hours before starting
operation.
to
Recommended temperatures
Heating: 22°C - 24°C
Cooling: 26 °C - 28 °C
Advertisement
Table of Contents
