Table of Contents
Advertisement
User Guide
5.4.3 Router Installation via 10/100 Base-T Ethernet and USB (Simultaneous
Installation)
The Dual Connect Router supports simultaneous use of 10/100 Base-T Ethernet and USB ports. The following
instructions explain how to install your Router using both Ethernet and USB ports.
1. Connect the power supply cord to the power connector marked
other end of the power supply cord into a surge-protected AC wall socket.
2. Connect the DSL phone cable from the jack on the rear panel of the Router marked
telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must use the
phone cord that was provided with the Router kit.
3. Connect the Ethernet cable from the Ethernet jack marked
port on your computer.
4. Connect the USB cable from the USB connector marked
on the PC.
Congratulations! You have completed the simultaneous hardware (Ethernet and USB) installation for your Dual
Connect NAT Router. Refer to your Internet service provider's instructions for installing subscriber software and
connecting to the Internet. You must now go to Section 6 to begin the USB software installation. (No software
installation is required when using an Ethernet connection.)
NOTE: Figure 3 illustrates a USB connection from the Dual Connect Router to a laptop. However, you may connect
the USB cable from the Dual Connect Router to any PC that has the minimum system requirements installed and
supports USB connectivity.
Plug the USB jack
into an available
USB connector on
the PC.
USB
Connector
Figure 3. Simultaneous Connection via 10/100 Base-T Ethernet and USB
030-300198 Rev. D
WireSpeed Dual Connect NAT Router
~
on the rear panel of the Router. Plug the
12V
on the rear panel of the Router to the Ethernet
on the rear panel of the Router to the USB port
8
to the DSL-equipped
March 2003
Advertisement
Table of Contents
