Advertisement
5. trOubleshOOting
P1, P2, P3 indicator lights on the power supply
are not lit.
Voltage meter display ".000", when the welder is
turned on.
P1 indicator light is not lit.
sparks. While steel tab welding
the stud did not weld properly. it can be easily
pulled off of the panel.
the stud burns through the panel.
no output when the trigger is pulled.
envirOnMent prOtectiOn
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
sealey group, kempson way, suffolk business park, bury st edmunds, suffolk. ip32 7Ar
01284 757500
© Jack sealey limited
1) check the power supply.
2) check the input cable.
3) Check the main switch.
4) there is a failure. Please contact the manufacturer.
1) Adjust the voltage control knob on the Welder.
2) Restart the Welder.
3) Trigger on and off several times.
4) there is a failure. Please contact to the manufacturer.
1) check the power supply,
2) check the input cable.
3) Check the main switch.
4) over heat protection, wait for welder to cool and restart.
1) check the ground pin for good connection.
2) check the work panel for oxidation or dirt.
3) Lower power setting.
4) increase pressure on ground pins & tabs when welding.
1) check stud height adjustment. stud head should be 2-4 mm past
the head of the ground pin.
2) check the ground pin is making good connection.
3) Check the work panel for oxidation or dirt.
4) increase output voltage.
1) reduce output voltage.
2) check the work panel for oxidation or contamination.
3) Adjust the gun, reduce pressure.
1) Check P1, P2, P3 indicator lights. All lights should be on.
2) Check the off/on switch.
3) Check the power supply to the welder.
4) Check the welding stud/tab and the ground pin have good
connection to the panel.
5) there is a failure. Please contact sealey stockist.
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
sR2000
Issue 1 15/06/18
Advertisement
