Advertisement
2
Assembling the Cage
Parts needed for this procedure:
1
Left door-cage assembly
1
Right door-cage assembly
1
Left door support
1
Right door support
1
Left lower-panel assembly
1
Right lower-panel assembly
1
Left door mount
1
Right door mount
1
Rear screen
1
Rear panel
2
Upper mount bracket
2
Lower mount bracket
4
Spacer
2
Spring mount
2
Spring
4
Ball stud
40
Bolt (5/16 x 3/4 inch)
44
Nut (5/16 inch)
10
Carriage bolt (1/4-20 x 3/4 inch)
10
Flange nut (1/4 inch)
Procedure
Refer to
Figure 2
as you perform the following steps.
Note:
Ensure that all parts are assembled loose.
Complete the assembly of the kit; then, tighten all
fasteners.
1.
Use bolts (5/16 x 3/4 inch) and flange nuts (5/16
inch) to secure the left and right door supports
to the top rails of the 2 Post ROPS Extension.
2.
Use bolts (5/16 x 3/4 inch) and flange nuts (5/16
inch) to secure the upper and lower mount
brackets and the left and right door supports to
the roll bar.
3.
Use bolts (5/16 x 3/4 inch) and flange nuts (5/16
inch) to secure the rear panel to the left and right
door supports.
4.
Use bolts (5/16 x 3/4 inch) and flange nuts (5/16
inch) to secure the rear screen to the rear panel
and the rear roof mount of the 2 Post ROPS
Extension.
Note:
Ensure that the holes in the rear screen
are aligned with the holes in the rear panel and
the rear roof mount.
5.
Use bolts (5/16 x 3/4 inch) and flange nuts (5/16
inch) to secure the rear screen to the left and
right door supports.
6.
Use bolts (5/16 x 3/4 inch) and flange nuts (5/16
inch) to secure the left and right door mounts to
the left and right door supports, respectively.
7.
Use bolts (5/16 x 3/4 inch) and flange nuts (5/16
inch) to secure the spring mounts to the top rails
of the 2 Post ROPS Extension.
8.
Use 10 carriage bolts (1/4-20 x 3/4 inch) and
10 flange nuts (1/4 inch) to secure the left and
right lower-panel assemblies to the foot platform
and the lower side brackets of the 2 Post ROPS
Extension.
You must drill holes into the foot platform.
A.
Mark the areas where the lower panel
assemblies meet the foot platform
1).
B.
Drill 4 holes (0.71 cm or 1/4 inch) into the
foot platform.
C.
Attach the carriage bolts and the flange
nuts.
2
(Figure
Advertisement
