Advertisement
Note:
If the height measured is more than
the zone specification, rotate the latch-pin cam
45° toward the inside of the cab to achieve the
specified measurement. If the height measured
is less than the zone specification, perform the
opposite of the above procedure.
Note:
The latch pin self centers.
Figure 5
1. Bubble seal
2. Cab rail
4.
Tighten the jam nut once the latch pin reaches
1.9 to 2.2 cm (3/4 to 7/8 inch) as shown in
4.
g036321
3. 1.9 to 2.2 cm (3/4 to 7/8
inch)
Figure
5
Adjusting the Doors
No Parts Required
Procedure
1.
Loosen the door-latch pin.
2.
Shut the door and use a ratchet strap to hold
the door
(Figure
Note:
Position an end of the ratchet strap on
the top frame rail and the other end on the door
handle.
1. Ratchet strap
2. Bolt and nut—door hinge
3.
Loosen the 4 bolts and the 4 nuts on the door
hinge
(Figure
6).
4.
Tighten the ratchet strap to pull the door up
(Figure
6).
Ensure that the gap measurement between the
door and the frame is 1.3 cm (1/2 inch).
5.
Tighten the bolts and nuts on the door hinge and
the door-latch pin.
6.
Remove the ratchet strap.
7.
Repeat the procedure for the other door.
6
6).
Figure 6
3. 1.3 cm (1/2 inch)
g205575
Advertisement
