Advertisement
3
Assembling the Door Latch
Parts needed for this procedure:
2
Jam nut
2
Pin guard
2
Latch-pin cam
4
Thrust washer
4
Lock washer
2
Latch pin
Procedure
1.
Ensure that you adjusted the control console to
the furthest inward position.
2.
Align the latch-pin cam with the opening at the
striker plate in the position shown in
1. Jam nut
2. Striker plate
3. Latch-pin cam
4. Thrust washer
3.
Insert the latch pin (without the washers at first)
into the latch-pin cam
4.
Add additional washers as needed to center the
latch pin in the door latch.
Note:
A combination of thrust washer and lock
washer may be needed to adjust the latch pin so
that it engages into the door latch.
5.
Align the latch pin and the jam nut onto the back
side of the opening at the striker plate
Figure
Figure 3
5. Lock washer
6. Latch pin
7. Pin guard
(Figure
3).
(Figure
6.
Tighten the jam nut onto the latch pin by hand
(Figure
3).
4
Adjusting the Door-Latch
Pins
No Parts Required
Procedure
1.
Center the latch pin in the latch-pin-mount
bracket on the rail
3.
g211832
2.
Close the door completely and view where the
latch pin comes into contact with the door latch.
Note:
If the latch pin does not completely
engage with the door latch, add washers
between the latch-pin cam and the latch pin.
3.
Close the door completely and measure the
height of the bubble seal to the sealing surface
of the cab rail, and ensure that the measurement
is 1.9 to 2.2 cm (3/4 to 7/8 inch) as shown in
Figure
5.
3).
5
(Figure
4).
Figure 4
g036952
Advertisement
