Advertisement
Installation
Installation is simply a matter of plugging in the cables. Please
refer to the diagram and follow the step by step directions:
Radio Frequency Energy, Certifications
Shielded cables must be used with this equipment to maintain
compliance with radio frequency energy emission regulations and ensure
a suitably high level of immunity to electromagnetic disturbances.
FCC Warning
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected
Consult the dealer or an experienced technician for help
You are cautioned that changes or modification not expressly approved
by the party responsible for compliance could void your authority to
operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including
interference that may cause undesired operation.
1. Plug the monitor cable into the unit's monitor port.
2. Plug one end of the computer video cable into an available
port on the unit's rear panel. Plug the other end of the
cable into the computer's video output port.
3. Repeat Step 2 for each computer to be connected.
4. Plug the supplied power adapter into the mains wall
outlet.
5. Connect the adapter to the Video Switch's power socket.
6. Power on all equipment.
Specifications
Function
Input
Connectors
Output
2 x 15 HD Female
LED's
Function Switches
Max. Video Resolution
Max. Cable Distance
Signal Type
Power Consumption
Weight
Dimensions (WxDxH)
2 Port Model
4 Port Model
1 x 15 HD Female
4 x 15 HD Female
Port x 2
Port x 4
1 x Push Button
1920 x 1440; DDC; DDC2; DDC2B
10m
VGA; SVGA; XGA; Multisync
100mA
150mA
220g
120 x 60 x 44mm
www.lindy.com
st
1
Edition Nov 2004
Advertisement
