Haier HTW130-186S User Manual page 13

Cleaning the overflow filter
Too much lint in the overflow filter will influence normal usage of the machine.
Remember to clean it once every two months.
1
Take off the overflow filter.
Nip the elastic fixing claw and
pull in the direction of the arrow
to remove (as demonstrated in
the figure to the right).
2
Clean the overflow filter.
Clean the lint around the filter and flush with tap water.
3
Re-install the overflow filter.
1) Install the corrugation pipe.
2) Attach the mounting plate
at the bottom of the filter onto
the valve cover.
3) Hang the hook on the left
upper side.
4) Push in the upper part.
Cleaning the unit
Wipe the entire unit with a

soft dry cloth.
Use neutral detergent to wipe

if the machine is excessively
dirty.
Do not apply water directly

when cleaning.
Petrol
Alcohol
After washing, disconnect the water intake hose.

Do not store water in the machine for long

periods of time. Drain the water immediately after
each use.
Pull out the power plug and hang up the power

cord.
Hang up the drain hose. Wipe off water drops on

the surface and inside the machine with a clean
soft cloth.
Thinner
Open the cover of the wash cycle compartment

and the inner/outer covers of the spin cycle
compartment for a short period (about one hour),
then close them.
Elastic fixing
claw
Hook
13