Advertisement
Advertisement
Related Manuals for Abicor Binzel ALPHA Series
Summary of Contents for Abicor Binzel ALPHA Series
- Page 1 ABICOR ALPHA SERIES Instruction Manual www.abicorusa.com...
-
Page 2: Table Of Contents
CONTENTS If installing a neck liner into a new swanneck or swanneck without old neck liner for measuring length: Page Fit the consumables (diffusor/insulator, tip-holder, contact tip, nozzle) onto the swan- neck. Neckliner lengths and installation .............. 3,4 Insert the neck liner into the swanneck as far as it will go. Installing gun (cable) liners ................ - Page 3 Installation of insulated steel liners in Euro At the machine end of the torch, slide the brass collet, and O-ring over the liner until they are seated in the rear connection. or direct mount guns Install the plastic liner nut, which is supplied in the connector kit. This is the nut with the large hole for the liner to exit through.
- Page 4 Installation of Plastic Liners for aluminum/ Assembly instructions for direct plug stainless steel in Euro Quick-Connect guns (continued) connector kits: Internal gas Refer to the diagram below: At the adaptor block end of the torch cable, slide the brass collet and O-ring over the liner until they are located in the recess in the adaptor block;...
- Page 5 Assembly instructions for direct plug connector kits: external gas (Lincoln std. shown) Gas hose Direct Plug Torch Rear End Allen key Connector Kit nipple Gas seal Lincoln Insulating Connector plug Standard sleeve Set screw Trigger lead jumper Slide the insulating sleeve over the connector plug (wide end facing the torch) and screw the plug into the torch rear end.
-
Page 9: Trouble-Shooting: Porosity
fi tting correctly. Consult the liner installation instructions on and/or sucking air at hose connections; 1b. Tighten all hose connection points. pages 2-6 or contact your local Authorized ABICOR Binzel Distributor creating venturi effect at end of gas nozzle. for additional help. -
Page 10: Swanneck Dimensions: Alpha 1
Try to start with as short a stick-out as possible and with the welding gun and fIow rate of gas and consult your local Authorized ABICOR Binzel as close to the starting point as possible. If a large ball end is formed a Distributor. -
Page 11: Swanneck Dimensions: Alpha 2
SWANNECK DIMENSIONS: ALPHA 2 THREADED SWANNECK DIMENSIONS: ALPHA 4 THREADED A4T-22 A2T-22 A2T-60 A4T-60 A2T-45 A4T-45 Approximate x and y measurements are in millimeters and are taken from the end of the contact tip with spray arc set-up. SWANNECK DIMENSIONS: ALPHA 3 THREADED A3T-22 A3T-60 A3T-45... - Page 12 Alexander Binzel Corporation 650 Medimmune Ct., Suite 110, Frederick, MD 21703-8619 Tel: 301.846.4196 Fax: 301.846.4497 www.abicorusa.com Alexander Binzel Corporation Binzel S.A. de C.V. Alexander Binzel Canada, Inc. 650 Medimmune Ct., Suite 110 Municipio de Pabellon de Arteaga 102 55 Mills Road, Units 1-3 Frederick, MD 21703-8619 Valle de Aguascalientes 20358 Ajax, Ontario L1S 2H2 Canada...
Need help?
Do you have a question about the ALPHA Series and is the answer not in the manual?
Questions and answers