Fault Display - Bonnet ADVANCIA STANDARD Manufacturer's Instructions

1.7.6 FAULT DISPLAY

Error messages may appear when the unit is first switched on or after prolonged use.
♦
The red alarm light will stay on permanently if there is a fault.
♦
The green alarm code light will illuminate once for a long period then flash a number of times
repeatedly. The number of flashes corresponds to the error code number
♦
These temporary indications do not mean there is necessarily a problem with the unit and it may
continue to be used.
♦
If the unit fails to function inform the service technician of the message, conditions and frequency it
appeared.
Problem...
The unit does not work the
display is blank
1
Error code number:
2
Error code number:
3
Error code number:
4
Error code number:
5
Error code number:
6
Error code number:
7
Error code number:
8
Error code number:
11
Error code number:
13
Error code number:
14
Error code number:
15
Error code number:
NOTE: When first connecting the unit wait a few seconds before touching the control panel to allow the electronics to stabilise.
Page 13
Possible causes
There is no electrical supply to the unit.
The supply or the connections are
faulty
The unit has not detected a pan.
The pan you are using is not suitable
for induction cooking
No inductor, no power to the supply
side
Ventilation ducting is blocked, fan is
dirty, probe has failed
Pan is empty or temperature probe
defective
Control unit is defective
Ventilation ducting is blocked, fan is
dirty, temperature probe has failed
The inductors temperature probe has
short circuited
An electrical phase is down
Hardware initialisation error
Control connected unnecessarily
Indicates local under or over voltage
Indicates under or over voltage to the
unit
Pan is empty or temperature probe
defective
What to do?
Check the state of the electrical
installation.
Put a pan on the heating area.
Use a suitable magnetic pan.
Check the inductor
Check the state of the electrical
installation. Connect the inductor
Clear the air circuit, clean the fan.
Remove the pan, wait until the cooking
surface cools down.
Replace the probe.
Check / replace the control unit.
Clear the air circuit, clean the fan
Check / replace the probe.
Check the phases
Wait the unit reboots automatically every
30 seconds.
Connect the controls to an appropriate
switch
Check the connections to the mains
Check the connections to the mains.
Remove the pan, wait until the cooking
surface cools down.
Replace the probe if necessary, switch the
unit off for a few minutes then on again
BONNET GRANDE CUISINE
Registered office:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
3BE390843NU – 01/12