Assembly - Weslo WLTL39201 User Manual

Weslo user's manual treadmill wltl39201
Table of Contents

Advertisement

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor-
mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply
wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. Note that the Right Handrail (32) and the Console
Base (not shown) are connected to the treadmill by
the Wire Harness (53). During assembly steps 1 to
4, be careful to avoid pulling on or damaging the
Wire Harness.
With the help of a second person, raise the Uprights
(38) to the position shown. Insert one of the Base
Legs (44) into the right Upright as shown. Make sure
that the Base Leg Pad (33) is in the indicated posi-
tion. Using the included Allen Wrench (81), attach
the Base Leg with a Base Leg Screw (39). Attach
the other Base Leg (not shown) to the left Upright in
the same way.
Note: One replacement Base Leg Pad (33) and
Spacer (not shown) are included. If a Base Leg Pad
becomes worn and needs to be replaced, use the
replacement Base Leg Pad with the Spacer.
2. Using the top and bottom holes in a Handrail
Spacer (3), attach the Handrail Spacer to the left
Upright (38) with two Long Screws (56). Make sure
that the ramps on the Handrail Spacer are on the
inner side as shown.
Attach the other Handrail Spacer (3) to the right
Upright (38) with two Long Screws (56) in the same
way.
3. Attach the Storage Latch (16) to the left Upright (38)
with the two Latch Screws (8). Be careful not to
overtighten the Latch Screws.
and adjustable wrench
1
2
Use these
holes
56
3
38
5
.
32
38
53
44
33
38
3
3
Ramps
56
8
16
81
39

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cadence ex16

Table of Contents