Table of Contents
Advertisement
7. Hold the Console (57) near the Console Base (52).
Touch the Right Handrail (59) to discharge any static.
Insert the Wire Harness (60) through the hole in the bot-
tom of the Console Base (52). Locate the two wires in
the Wire Harness (60) that have L-shaped connectors
on the ends. Press the connectors onto the two tabs on
the switch shown in inset drawing 7a. Connect the other
two wires in the Wire Harness to the back of the
Console (57) in the locations shown by the arrows in
drawing 7. If the connectors do not fit together
easily, rotate them and then connect them.
Make a loop with each of the indicated plastic ties around
the Wire Harness (60). Securely tighten each plastic
tie to prevent the Wire Harness from slipping. Cut off
the ends of the plastic ties.
8. Set the Console (57) in the Console Base (52). Cover
the Wire Harness (60) with the Wire Cover (11), and
route the Wire Harness out of the hole in the side of the
Wire Cover. Attach the Wire Cover to the back of the
Console Base with two 3/4" Screws (2). Make sure that
no wires are pinched before you attach the Console
to the Console Base.
Tighten four 3/4" Screws (2) into the Console Base (52)
and the Console (57). Do not over tighten the Frame
Bolts (70).
9. Attach the Storage Latch (48) to the Left Upright (53)
with two 3/4" Screws (2).
10.Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep
the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page
13). To protect the floor or carpet, place a mat under the treadmill.
7
52
Ties
8
11
59
60
2
9
48
7
57
60
60
7a
Tabs
59
52
57
2
2
53
2
45
Advertisement
Table of Contents
