Weslo WLTL25320 User Manual page 6

3. With the help of a second person, attach the Base (46)
to the Right Upright (62) with two Upright Bolts (65), two
3/8" Washers (66), and two 3/8" Nuts (61) as shown.
Attach the Base (46) to the Left Upright (not shown) in
the same way.
4. Raise the treadmill to the upright position.
If there are plastic ties in the brackets on the Left and
Right Handrails (45, 59), remove them. Hold the Right
Handrail near the Right Upright (62). Insert the Wire
Harness (60) up through the bracket on the Right
Handrail and out of the round hole in the center of the
Handrail. If necessary, use needlenose pliers to pull the
Wire Harness out of the hole. Be careful not to damage
the Wire Harness. Insert the brackets into the tops of
the Left and Right Uprights (53, 62).
Hand tighten four Handrail Bolts (42) with 1/4" Washers
(38) into the Uprights (53, 62) and the Handrails (45, 59).
Remove the tape from the connectors at the end of the
Wire Harness (60).
5. Set the Console Base (52) on the Handrails (45, 59).
Thread four 3/4" Screws (2) into the Handrails and the
Console Base. After you have started all four Screws,
tighten the Screws until they are snug; do not over-
tighten the Screws.
Firmly tighten but do not overtighten the bolts used
in steps 2 through 4.
6. Insert the Battery Cover (54) up through the bottom of
the Console Base (52), with the hinges in the position
shown. The Cover should pivot down, away from the
Console Base.
3
62
4
45
38
42
5
59
2
6
6
65
66
61
46
Connectors
60
42
38
59
Bracket
53
38
42
38
52
2
52
Hinges
54
42
62
45