Do you have a question about the ACW10 and is the answer not in the manual?
Questions and answers
Karl Zarb
March 28, 2025
hi i have two dls acw10 installed in my car, i have noticed one of the amps had blown the fuse, i have tried replacing the fuse however it does not switch on, it indicated protect mode and then both leds are off. what could the cause be ?
1 comments:
Mr. Anderson
March 28, 2025
The DLS ACW10 amplifier could go into protect mode and not turn on after replacing the blown fuse due to the following reasons:
1. Short circuits on the speaker leads. 2. Overdriving from the head unit (volume set too high). 3. Faulty amplifier requiring servicing. 4. Improper grounding. 5. Remote input (Turn-On) voltage less than 5VDC.
These issues should be checked and corrected before repowering the amplifier.
Need help?
Do you have a question about the ACW10 and is the answer not in the manual?
Questions and answers
hi i have two dls acw10 installed in my car, i have noticed one of the amps had blown the fuse, i have tried replacing the fuse however it does not switch on, it indicated protect mode and then both leds are off. what could the cause be ?
The DLS ACW10 amplifier could go into protect mode and not turn on after replacing the blown fuse due to the following reasons:
1. Short circuits on the speaker leads.
2. Overdriving from the head unit (volume set too high).
3. Faulty amplifier requiring servicing.
4. Improper grounding.
5. Remote input (Turn-On) voltage less than 5VDC.
These issues should be checked and corrected before repowering the amplifier.
This answer is automatically generated