Bernina Industrial 950 Instruction Manual page 3

IMPORTANT! SAFETY INSTRtJCTIONS
The following safety instructions should always be
followed:
Before using the machine, read the safety instructions
and the instruction manual carefully.
Please follow the instructions below very carefully when
setting up, operating and cleaning the appliance!
Use this appliance only for its intended use as descri­
bed in this manual.
Never operate the appliance if parts are defective or
missing.
The appliance may only be operated when all protec­
tive covers are correctly fitted.
The motor voltage mentioned on the specification
plate must correspond with the electrical voltage of
the place where the appliance is used. Do not use
the machine if this is not the case.
Use only attachments recommended by the manu­
facturer as contained in this manual.
Never operate the machine where aerosol (spray
products) are being used or where oxygen is being
administered.
Keep flammable and volatile liquids weil away from
the appliance.
Switch the machine off or remove the plug from the
power supply when making any adjustments in the
needle area.
Always unplug the machine from the electrical supply
when cleaning or lubricating or when work is comple­
ted. In addition wait until the machine has come to a
complete standstill when using a clutch motor.
Always unplug by grasping the plug and not the
Do not press the foot control when switching the
appliance on.
The needle and other moving parts (thread take-up,
hook and handwheel) are sources of injury (injury to
fingers). lt is therefore important to keep your eyes on
to work.
Always use the prescribed needle
blunt or damaged needles.
Keep ventilation openings of the motor and foot con­
trol free from the accumulation of lint, dust and loose
cloth
Before tilting the machine, turn the power switch to
"O", remove the plug from the power supply and let
the machine come to a complete standstill. Be careful
of sharp, protruding parts and when tilting the machi­
ne back again, make sure that your fingers do. not get
trapped between the machine and the sewing table.
Keep these instructions carefully for your own safety.
DANGER!
When you change the presser foot, it is essential that
the finger guard supplied with the machine is attached
to the new foot. This does not apply to special presser
feet because it would affect their performance, but
extra care is required when using these
cable.
Safety instructions
system. Do not use
feet.