Introduction - Fujitsu BS2000 SE Series Quick Manual

1 Introduction

With the FUJITSU Server BS2000 SE Series (SE servers), FUJITSU offers a server infrastructure which consists of
two server lines.
Depending on requirements, an SE server contains all the system components needed for operation as an overall
application:
/390-based BS2000 Server Unit
x86-based Server Units with BS2000 guest systems, SU300 also with Linux or Windows guest systems as an
option
x86-based Application Units for operation under e.g. Linux, Windows or VMware
Shareable tape and disk periphery
A high-speed, server-internal infrastructure to connect the components with each other and with the customer
LAN or SAN.
Information on using the Quick Guide
This Quick Guide is intended for people who operate an SE server and contains short instructions for the most
important scenarios when placing the SE server in service. The following requirements should be met:
Customer Support provides the customer with the SE server.
The desired BS2000 operating mode is set on each Server Unit.
A BS2000 system is configured and fully operational.
All necessary BS2000 devices are configured.
i
Please note the following:
The base system of the MU (M2000) as well as the iRMC of the MU have a predefined administrator
account admin at the time the SE server is delivered. In both cases an initial password is preset, which
you can ask for at the service.
Change the password immediately after you have logged in for the first time.
You may also change the validity time and the other password attributes.
You can access the password management as follows:
in SE Manager: Authorizations -> Users -> Password management
on the iRMC S4: User management -> iRMC S4 users
on the iRMC S5 (with MU M3): Settings
A detailed description of the SE Manager's functionality with the usage of the base software (M2000/X2000/HNC)
V6.3A is included in the "Operation and Administration" manual and in the SE Manager's online help.
User Management
-> ->
iRMC Local user accounts
5