Fujitsu BS2000 SE Series Quick Manual page 20

> To load BS2000, enter
DETAIL-1 frame will appear.
You can start execution of IPL with the entries in this frame.
The frame shows, among other things, the (current and preset) load device (also called IPL or boot load
device) of BS2000. As the Server Unit was rebooted, the IPL load device from the auto IPL configuration is
set. This can differ from the IPL load device of the last IPL. If necessary, select a different load device under
.
IPL DEVICE
i
Initial startup from the IPL load device requires a DIALOG startup.
be selected for this purpose.
Take note of the setting for
(displayed here as
VM MODE : AVM/EX PARMS ==> 1
be entered there.
> In VM2000 mode, switch to the PROGRAM LOAD FRAME: DETAIL-2 if necessary using PF9 in order to
check the settings for loading the VM2000 firmware.
In VM2000 mode,
VM MODE ==> 2
> For
LOAD FUNCTION ==>
> Please monitor the further procedure on the BS2000 console. Take note of the console messages and
answer the question messages.
As a large number of messages are output one after the other, question messages can also quickly
"disappear". The /SHOW-PENDING-MSG (or /STATUS MSG) command enables you to have all the open
question messages displayed again.
As soon as the message NSI0000 displays "System ready", startup of BS2000 has already been largely completed.
You can continue to observe the current BS2000 session on the console and, when necessary, react to system
messages (e.g. reply to a mount message).
and press the Enter key. The PROGRAM LOAD FRAME:
FUNCTION ==> ld
. This depends on the BS2000 operating mode set. In VM2000 mode
PARMS ==>
),
must be set there.
select one of the functions
LOAD FUNCTION ==> 3
must be set. In Native BS2000 mode, a blank must
or and press the Enter key.
LOAD START
must
20