Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Sierra Wireless PinPoint XT
Summary of Contents for Sierra Wireless PinPoint XT
- Page 1 CoverTitle PinPoint XT Quick Start Guide for Verizon 20070914 Rev 1.0A...
- Page 2 One of the special features of your PinPoint XT for Verizon is the ability to activate itself automatically. When you first power on the PinPoint XT, it will check to see if it has been activated with account data. If it finds that it has not yet been activated,...
- Page 3 For the updater tool to execute, please install the USB drivers available on the website before executing the .exe file. Copy the USB Serial Driver.inf file to your desktop. Then power up the PinPoint XT Tip: and connect USB. Install from specific location and point to this .inf file. For detailed instructions on installing the USB drivers, please refer to Universal Serial Bus Application Note.
- Page 4 Note: You can use Boot interface only when a serial cable connection is established. The default private for Ethernet is also in a different subnet from the other connection types. Table 2-1: Factory Defaults Interface PinPoint XT Connected Device Ethernet Private default 192.168.13.31* 192.168.13.100 USB/NET 192.168.14.31...
-
Page 5: Verifying Usb Connection
PinPoint XT Figure 2-3: Configuration: Interface selection c. The next screen will prompt you to reset the modem manually. Click on Next after resetting the modem manually. Installation begins and can take up to a few minutes. Once the installation is complete, you will get a confirmation screen. -
Page 6: Confirming Ip Address
Configuring through ACEmanager ACEmanager is a free utility. Follow the steps below to connect to ACEmanager for configuring the modem. • Ensure PinPoint XT connectivity to access ACEmanager. • Go to: http://192.168.13.31:9191 the first time you connect to ACEmanager. Rev 1.0A Mar.10... -
Page 7: Activating Using At Commands
PinPoint XT Activating Using AT Commands An alternate method to configure and activate your PinPoint XT is by using AT commands sent directly to the modem with a terminal application. Caution: It is not possible to activate the PinPoint XT using either ACEmanager or AceNet. - Page 8 PassThru can only be exited by resetting or power-cycling the modem. This mode cannot be entered via a remote Telnet session. You can configure a string of AT commands to be sent to the PinPoint XT when it enters PassThru and other PassThru settings.
- Page 9 PinPoint XT 20070914...
Need help?
Do you have a question about the PinPoint XT and is the answer not in the manual?
Questions and answers