Table of Contents
Advertisement
Device Installation
Turning on the Companion mini (Monitor)
The monitor (companion mini) is shipped in a low power state and needs waking
up before use.
The monitor is woken up by pressing the recessed "Test" button on the front of
the monitor [Figure 1], typically using a pen tip.
When the monitor is woken up, it firstly enters a 60 second "Test Mode" before
falling into normal operation. The red "Alarm" LED will flash to indicate the unit
is now turned on and in "Test Mode". Test mode allows the user to easily test the
positioning of the monitor [See page 10], after which it will operate normally and
the LED will stop flashing until an alarm condition is detected.
Figure 1.
mini
Turning off the Companion
(Monitor)
The mini will run for over a year in continuous use, however if the companion
mini is no longer needed it can be turned off by press and holding the "Test"
button for 8 seconds. The red light will flash rapidly for 1 second upon shutting
down.
Please Note: After turning the companion mini off, any device that it is paired
with will now raise an "RF Fail" alarm after 2 minutes. This is due to the devices
no longer receiving the 8 second Safelink signals from the mini that they are
expecting. To stop the warning the mini will need to be unpaired from the device
or deactivated on the pager.
Advertisement
Table of Contents
Need help?
Do you have a question about the Companion mini pro and is the answer not in the manual?
Questions and answers