Positioning The Companion Mini Pro - Alert-it Companion mini pro Manual

Positioning the Companion Mini Pro

The monitor performs best if placed beneath the user. However, due to
the wide variety of bed types and mattresses, it is advisable to test the
units positioning before securing it into place.
Put the companion mini into "Test Mode" by briefly pressing the recessed
"Test" button on the front of the monitor.
("Test Mode" is a 60 second window, whereby each time the mini detects
a movement it transmits a test code to the pager. This allows the user to
test positioning of the monitor under the mattress.)
Temporarily place the monitor under the mattress without any fixings.
Tap or press the bed to simulate seizure movements.
The pager will temporarily display "Assist +1" and a short audible tone is
played each time the Companion Mini detects movement.
If you are happy that the monitor is picking up each press/tap of the
mattress then you can secure it into position using the supplied Velcro
pads or cable ties.
To use the tie wrap you must remove the base and thread the tie wrap
through the hole's as shown in figure 3 and 4.
If required, the base can be screwed to the bed through the holes in the
base (screws not provided)
Please contact Alert-iT customer support for more information if assist-
ance is needed.
Figure 3.
Figure 4.