Advertisement
Electronic Control Operation
(A)
( B)
(F)
Note: Control panel coloring may vary by
model
Control Panel Features
(A) LED DISPLAY
(B) TIME ENTRY KEY
(C) X2 KEY
(D) POWER LEVEL KEYS
(E) NUMBER KEYS /
PRESET PROGRAM KEYS
STOP/RESET KEY
(F)
(G) START KEY
The switching operation of this microwave oven can cause voltage fluctuations on the supply line. The operation of this oven under unfavorable
voltage supply conditions can have adverse effects. This device is intended for the connection to a power supply system with a maximum
permissible system impedance Zmax of 0.2 Ohms at the interface point of the user's supply. The user has to ensure that this device is
connected only to a power supply system which fulfills the requirement above. If necessary, the user can ask the public power supply company
for the system impedance at the interface point.
16500066
So...how do I use it?
Interrupting Operation (Pause Mode)
While the oven is operating, press STOP/RESET key
Display shows remaining cooking time. Close door and press START key
(C)
resume oven operation.
Canceling Mistakes
(D)
If oven is not cooking, press STOP/RESET key
cooking, press STOP/RESET key
If oven door is open and time shows in display, close oven door and press STOP/
RESET key
to clear display.
Manual Time Entry Mode
(E)
Time entry mode allows the user to manually enter a cook time and power level.
1.
Open oven door and place food in oven. Close door.
2.
Press the TIME ENTRY key
(G)
3.
Press Number Keys to enter the desired cook time.
4.
Press POWER LEVEL key
display the related power. If the same key is pressed twice, the power will change
to PL10 (Power Level 10 or full power). If no power chosen, PL10 is default.
5.
Press START key
displays cooking time.
At the end of the cooking cycle, the oven beeps and LED displays "End".
6.
Operating Preset Program Keys
From the factory, this oven can of store up to 10 preprogrammed cooking sequences
in memory, for one key touch operation.
1.
Open oven door and place food in oven. Close door.
2.
Press a Number Key to run the Preset Program associated with that key. Oven
begins cooking and the LED displays cooking time.
At the end of the cooking cycle, the oven beeps and LED displays "End".
3.
FACTORY PRESET PROGRAM SETTINGS
NUMBER KEY
1
2
3
4
5
6
7
8
9
0
*Note: Factory setting may vary by model
once to stop oven, then again to clear display.
. "00:00" is displayed.
,
,
or
to begin cooking. Oven begins cooking and the LED
TIME
POWER
10 sec.
20 sec.
30 sec.
45 sec.
1:00 min.
100%
1:30 min.
2:00 min.
3:00 min.
4:00 min.
5:00 min.
6
to interrupt operation.
to
to clear display. If oven is
to select power level. LED will
July 2019
©2019 ACP, Inc.
Advertisement
