Service And Maintenance; Fluids And Lubricants; Greasing - Walinga Ultra-Vac 6614D Operator's Manual

5 SERVICE AND MAINTENANCE

5.1 SERVICE

5.1.1 FLUIDS AND LUBRICANTS

1. Grease:
Use an SAE multi-purpose high temperature
grease with extreme pressure (EP)
characteristics.
Also acceptable is an SAE multi-purpose
lithium based grease.
2. Blower Oil:
Use Walinga Blower oil part# 98-13813-5 (4 liters) or
Walinga Blower oil part# 98-93866-5 (2o liters)
Table 4
MODEL
6614D
. 7614D
LOCATION
Front (drive)
Rear (idle) 2 litres
Total 3 litres
Storing Lubricants:
Your unit can operate at top efficiency only if
clean lubricants are used. Use clean containers to
handle all lubricants. Store them in an area
protected from dust, moisture and other
contaminants.

5.1.2 GREASING

Refer to Section 5.1.1 for recommended grease.
Use the Service Record checklist provided to keep
a record of all scheduled servicing.
1. Use a hand-held grease gun for all greasing.
2. Wipe the grease fitting with a clean cloth
before greasing, to avoid injecting dirt and grit.
3. Replace and repair broken fittings
immediately.
4. If the fittings will not take grease, remove and
clean thoroughly. Also clean the lubricant
passageway. Replace the fitting if necessary.
7816D
1 litre 5 litres
6 litres
11 litres
8614D