Table Of Contents - Beckett AF Series Manual

To the Owner:
Thank you for purchasing a Beckett
burner for use with your heating appliance.
Please pay attention to the Safety Warnings
contained within this instruction manual.
Keep this manual for your records and
provide it to your qualified service agency
for use in professionally setting up and
maintaining your burner.
Your Beckett burner will provide years of
efficient operation if it is professionally
installed and maintained by a qualified
service technician. If at any time the burner
does not appear to be operating properly,
immediately contact your qualified
service agency for consultation.
We recommend annual inspection/
service of your heating system by a
qualified service agency.
Daily - Check the room in which your
burner/appliance is installed. Make sure:
Air ventilation openings are clean and
y
unobstructed
Nothing is blocking burner inlet air
y
openings
No combustible materials are stored
y
near the heating appliance
There are no signs of fuel or water
y
leaking around the burner or appliance
Weekly
Check your fuel tank level. Always
y
keep your fuel tank full, especially
during the summer, in order to prevent
condensation of moisture on the inside
surface of the tank.
2
Contents
General Information .................................................... 3
Hazard Definitions ........................................................................
Remainder of manual to be used ONLY BY
▼
QUALIFIED SERVICE TECHNICIANS
Inspect/Prepare Installation Site .............................6-7
Inspect Chimney or Direct Vent System ........................................
Combustion air supply ...................................................................
Clearances to burner and appliance .............................................
Combustion chamber - Burner retrofitting ...................................
Prepare the Burner ...................................................8-9
Burner fuel unit ..............................................................................
Attach air tube (if not already installed) .........................................
Nozzle and Pump Pressure ..........................................................
Install burner nozzle (if not already installed) ................................
Check/adjust electrodes ................................................................
Servicing nozzle line assembly .....................................................
Low Firing Rate Baffle ...................................................................
Mount Burner on Appliance ..................................9-13
Mounting options ...........................................................................
Mounting dimensions ....................................................................
Check/Adjust 'Z' Dimension - 'F' heads ......................................
Installing the Fuel Tank and Supply System ........................
Wire burner ...........................................................13-14
Burner packaged with appliance ................................................
Burner installed at jobsite ...........................................................
Special wiring required for burners with covers .........................
Wiring .........................................................................................
Burner Controls ......................................................... 15
Start Up Burner/Set Combustion ........................16-18
Resetting from restricted or hard lockout ...................................
Cad Cell Resistance Measurement ............................................
Startup / Checkout .....................................................................
Check Safety Features ...............................................................
Set combustion with instruments .........................................
Perform Regular Maintenance.................................. 18
Shutting the Burner Off ..............................................................
Replacement Parts ...............................................19-22
Start Up Report .......................................................... 23
Limited Warranty Information .................................. 24
3
▼
6
7
7
7
8
8
8
8
9
9
9
9
9
10
12-13
13
13
13
14
16
16
17
17
17-18
18