Spektrum AR8010T User Manual page 6

EN
Bind Button AR8010T/AR9030T
Preset Failsafe
Move all sticks and switches on
1 the transmitter to the desired
failsafe positions
2 Push and hold bind button
3 Power ON receiver
Put transmitter in bind mode and
4
allow it to fi nish binding.
Release bind button after bind
5
process is complete
Bind Plug AR8010T/AR9030T
Preset Failsafe
Move all sticks and switches on
1 the transmitter to the desired
failsafe positions
2 Insert bind plug in the bind port
3 Power ON receiver
Remove the bind plug when the
4 RX goes into bind mode (orange
fl ashing LEDs)
Put transmitter in bind mode and
5
allow it to fi nish binding
Remove the bind plug after binding or the receiver will enter bind mode again
the next time it is powered ON. Always remove the bind plug before fl ight.
If at any time you turn on the system and it fails to connect, verify the correct
model memory is selected in the transmitter.
After Connection
When the transmitter and receiver are connected, the orange LEDs on the main
receiver unit and remote receivers will remain illuminated. If for any reason
a failsafe is triggered, the system will immediately regain control upon the
connection being restored.
6
Smart Safe + Hold Last
Lower throttle on transmitter
Push and hold bind button
Power ON receiver
Release button once RX goes
into bind mode (orange fl ashing
LEDs)
Put transmitter in bind mode
and allow it to fi nish binding
Smart Safe + Hold Last
Lower throttle on transmitter
Insert bind plug in the bind port
Power ON receiver
Put transmitter in bind mode
and allow it to fi nish binding
Remove bind plug