Spektrum AR8010T User Manual page 11

Problem
Transmitter too near aircraft
during connecting process
Aircraft or transmitter is too
close to large metal object,
wireless source or another
transmitter
Aircraft will
Bind plug left installed in
not con-
bind port
nect (after
binding) to
Aircraft bound to different
transmitter
model memory
(ModelMatch
Flight battery/Transmitter
battery charge is too low
Transmitter may have been
bound to a different aircraft
using different DSM protocol
Control surface, control horn,
linkage or servo damage
Wire damaged or connec-
tions loose
Control
surface
Transmitter is not bound
does not
correctly or the incorrect
move
airplanes was selected
Flight battery charge is low
BEC (Battery Elimination Cir-
cuit) of the ESC is damaged
Possible Cause
TM
radios only)
Solution
Move powered transmitter a few
feet from aircraft, disconnect and
reconnect fl ight battery to aircraft
Move aircraft and transmitter
to another location and at-
tempt connecting again
Rebind transmitter to the
aircraft and remove the bind
plug before cycling power
Select correct model memory
on transmitter
Replace/recharge batteries
Bind aircraft to transmitter
Replace or repair damaged
parts and adjust controls
Do a check of wires and con-
nections, connect or replace
as needed
Re-bind or select correct air-
planes in transmitter
Fully recharge fl ight battery
Replace ESC
EN
11