Useful Advice; Temperature Control; Operation - Imetec PIASTRA Instructions And Warnings

G E N E R A L
DESCRIPTION OF THE APPLIANCE AND ACCESSORIES
Plates
b Power cord
c Electronic temperature control
d On/off button
I N S T R U C T I O N S

USEFUL ADVICE

Quickly gained experience in using your hair straightener will help you
determine exactly how long to set the hair for the effect you want.
- Each time you use your straightener make sure that your hair is perfectly
dry, clean and free from all traces of hairspray, mousse or gel;
- Use the temperature control system to heat the straightener to the
temperature which is suitable for your hair. We suggest using a low
temperature on fine hair and high temperatures on thick hair that is difficult
to straighten;
- Start styling from the back of the neck, then on the sides and end with the
forehead;
- When using the hair straightener and during the heating up and cooling
down phases, place it on a smooth and heat-resistant surface;
- While styling, take care not to bring the straightener too close to sensitive
areas of the face, the ears, the neck or the skin;
- After use, let the hair straightener cool down completely before putting it
away.
Warning:
When you have finished using the hair straightener, make sure it has
cooled down completely before putting it away.
PREPARING THE HAIR
- Wash the hair as usual and brush out any tangles.
- Dry the hair, brushing it from the roots to the tips.

TEMPERATURE CONTROL

Your hair straightener comes with an electronic temperature regulator. This
allows you to control the temperature of the plates to two different levels
(200° and 220°C) according to your hair type.
Warning:
Please refer to the technical specifications on the box for more
information on your hair straightener.

OPERATION

- Plug in the hair straightener; set switch d to position 1 and let it heat up;
- A red light e comes on to indicate that the appliance is switched on; set
the right temperature by turning the switch to position 1 (200°C) or to
position 2 (220°C);
I N S T R U C T I O N S
e Operation light
f Handle
8
[Fig. Z]
F O R U S E