Weider WESY47330 User Manual page 14

20. Route the Lat Cable (62) up through the Top
Frame (9), over a 100mm Pulley (38), and back
down through the Top Frame. Attach the Pulley
inside the Top Frame with an M10 x 65mm Bolt
(80), two M10 Washers (99), two 12.5mm
Spacers (69), and an M10 Nylon Locknut (101).
21. Wrap the Lat Cable (62) under a 100mm Pulley
(38). Attach the Pulley to the Double "U"-bracket
(42) with an M10 x 45mm Bolt (51) and an M10
Nylon Locknut (101).
22. Route the Lat Cable (62) up through the Top
Frame (9) and over a 100mm Pulley (38). Attach
the Pulley inside the Top Frame with an M10 x
65mm Bolt (80), two M10 Washers (99), two
12.5mm Spacers (69), and an M10 Nylon Locknut
(101).
23. Route the Lat Cable (62) over a 100mm Pulley
(38) and down through the Top Frame (9). Attach
the Pulley inside the Top Frame with an M10 x
65mm Bolt (80), two M10 Washers (99), two
12.5mm Spacers (69), and an M10 Nylon Locknut
(101).
24. Set the tether on a Weight Pin (98) over the Long
Weight Tube (23). Set a 50mm Washer (95) on
the Weight Tube.
Thread an M12 Nut (58) all the way onto the Lat
Cable (62). Screw the Cable partway into the
Long Weight Tube (23). Tighten the Nut against
the 50mm Washer (95).
20
101
99
21
62
101
42
22
101
99
69
9
23
38
101
99
69
9
24
58
23
14
38
69
62
99
69
9
38
51
62
38
69
99
80
69
99
80
62
62
98
95
80