Weider WESY47330 User Manual page 10

7. Press a 50mm x 75mm Inner Cap (46) into the
Top Frame (9).
Slide the welded tubes on the Top Frame (9) over
the upper ends of the Weight Guides (18, 19).
Attach the Top Frame (9) to the Butterfly Upright
(2) with two M10 x 75mm Bolts (82) and two M10
Nylon Locknuts (101). Do not tighten the
Locknuts yet.
Attach the Top Frame (9) to the Weight Guides
(18, 19) with four M10 x 45mm Bolts (51) and
four M10 Nylon Locknuts (101). Do not tighten
the Locknuts yet.
8. Press a 50mm Thick Square Inner Cap (47) into
the Sliding Seat Frame (8). Press a 50mm Square
Inner Cap (45) into the indicated end of the Seat
Adjustment Frame (4). Press the Metal Plate (44)
and the 50mm Angled Outer Cap (43) onto the
other end of the Seat Adjustment Frame.
Tighten a "T"-handle (59) into the Sliding Seat
Frame (8). Turn the "T"-handle counterclockwise
to loosen it. Pull out the handle as far as possible
and slide the Seat Adjustment Frame (4) into the
Sliding Seat Frame. Release the handle and let it
engage one of the adjustment holes in the Seat
Adjustment Frame. Then, tighten the handle.
9. Attach the Seat Adjustment Frame (4) to the Leg
Press Base (3) with four M10 x 65mm Carriage
Bolts (88) and four M10 Nylon Locknuts (101).
Tighten the M10 Nylon Locknuts (101) used in
steps 1–3 and 7–9.
7
101
46
19
8
47
59
45
9
88
101
3
10
9
82
51
2
18
8
44 43
4
88
4
101
101
101
101