Table of Contents
Advertisement
System Information
-
The first line allows the user to give the unit a name.
-
The second line allows the user to set the security to high or low by pressing <Enter>. If set to "high"
the Main Menu cannot be accessed without the correct password.
-
The third line allows the user to enable or disable upgrades through the TFTP program.
-
The fourth line of the System Information sub-menu shows if the unit is configured as a CO (Central
Unit or Local Unit) or a CP (Customer Premise or Remote Unit) device.
-
The next four lines display the currently assigned Ethernet Address, the IP Address, serial number
and hardware version number, respectively.
-
The ninth line displays the Firmware Version. You should check the Black Box Web site
(www.blackbox.com) to see if this is the latest version. If not, you should upgrade your firmware.
-
The tenth line is the Firmware Checksum. You should record this checksum and compare it with the
displayed one every time the unit is reset or power-cycled. This checksum should be the same; if it
changes, the unit's firmware has been corrupted. In this case you have to reload the firmware.
Remember each new firmware version has a different checksum.
-
EXAMPLE OF SUB
MENU
===== System Information =====
. System Name
. Security Level
. Allow TFTP Download
. The Device Configured as :
. Ethernet Address
. Device Main IP Address
. Controller Serial No.
. Controller HW Version
. Firmware Version
. Firmware Checksum
Ctrl-s
Save all
Press Esc to return to the main menu
Traffic Statistics
The Statistics sub-menu 2 provides traffic statistics from/to the Ethernet port and from/to the DSL port.
-
Ethernet Packets Received: Number of Ethernet packets that have been received from the LAN
-
Ethernet Packets Sent: Number of Ethernet packets that have been sent to the LAN
-
Ethernet Tx + Rx Error: Number of Ethernet packets received or transmitted on the Ethernet port that
have errors
-
DSL Line Packets Received: Number of packets from the remote LAN that have been received from
the DSL line
-
DSL Line Packets Sent: Number of packets from the directly connected LAN that have been sent
onto the DSL line
-
DSL Line RX Packets Errors: Number of packets received from the DSL line that have errors
-
Current Error displays any error that the system may have
#1:
SYSTEM INFORMATION
:
S002
:
Low
:
N
CP
:
00 E0 F3 00 05 14
:
194.
:
00C09C84D30E
:
1
:
Ag200 2.19
:
7B5C
© 2002 Black Box Corporation
DSL LAN Extender 200 User's Guide
1.
2.
1
Page 8
Advertisement
Table of Contents
