Table of Contents
Advertisement
Network Mode Configuration
The Network Mode Configuration screen allows the user to change a variety of functions.
-
The user can enable either or both Bridging and RIP functions.
-
The user can change the devices main IP Address, Subnet Mask and Default Gateway.
-
A Bandwidth Limit can also be set for inbound and outbound traffic (a setting of 0 means that the
traffic control is not activated and it will allow whatever traffic the network can support).
-
For the Remote CP device, NAT can be enabled, with optional setting for e-mail and http/ftp servers.
The appropriate IP addresses must be entered.
Network Mode Configuration - Local (CO) Side
===== Network Mode Configuration =====
. Device Serves at Side
. Bridging Enabled
. RIP Enabled
. Device Main IP Address
. Device Main IP Subnet Mask
. Ethernet Side Default Gateway
. Bandwidth Limit, Outbound(Kbit/s):
. Bandwidth Limit, Inbound(Kbit/s) :
Ctrl-s
Save all
Press Esc to return to the main menu
Network Mode Configuration – Remote (CP) Side
===== Network Mode Configuration =====
. Device Serves at Side
. Bridging Enabled
. RIP Enabled
. Device Main IP Address
. Device Main IP Subnet Mask
. Ethernet Side Default Gateway
. Bandwidth Limit, Outbound(Kbit/s):
. Bandwidth Limit, Inbound(Kbit/s) :
. NAT Enabled
(Items below have no effect unless NAT is enabled)
. Device NAT IP Address
. NAT Subnet Mask
. E-mail Server Enabled
. E-mail Server's IP Address
. HTTP/FTP Server's IP Address
Ctrl-s
Save all
Press Esc to return to the main menu
By default, the DSL LAN Extender CO and CP devices are pre-assigned the same IP address at the
factory: 192.168.100.1. You should assign the DSL LAN Extender device a valid host IP address in the
same subnet as the Ethernet to which it is directly connected.
: CO
: N
: N
: 194.
1.
1.
2
: 255.255.255.
0
: 194.
1.
1.
1
256
256
:
Remote
: Y
: N
: 194.
1.
2.
1
: 255.255.255.
0
:
0.
0.
0.
0
256
256
: Y
: 192.168.
1.
1
: 255.255.255.
0
: Y
: 192.168.
1. 10
:
0.
0.
0.
0
© 2002 Black Box Corporation
DSL LAN Extender 200 User's Guide
Page 10
Advertisement
Table of Contents
