TOPRO TAURUS E Basic User Manual page 18

EN
Technical details electrical components
Controller box: C3con1-x, manufacturer Concens AS, Denmark
Actuator: Con 5, manufacturer Concens AS, Denmark
Battery: C3 NiMH 24 V – 1400 mAh, manufacturer Concens AS, DK
Battery charger: C3-CHG-05-XX-00, consists of Mascot NiCd/NiMh
charger, type 2215 with IP4X, manufactured by Mascot Electro-
nics AS and Battery Case type C4-947-01-0000-00-00, manufactu-
red by Concens AS. The Overall IP for the charger system (C3-
CHG-05-XX-00) is IP4X. The C4-947-01-0000-00-00 battery case
can be only used with type 2215 Mascot NiCd/NiMh charger.
Duty Cycle: 10% maximum activation (on) time 2 minutes and
the minimum deactivation (off ) time 18 minutes.
Input voltage: 100–240VAC
Guidance and manufacturer's declaration
Electromagnetic EMISSIONS for all ME EQUIPMENT and ME SYSTEMS
The TOPRO TAURUS walking aid is intended for use in the electromagnetic environment specified below.
The customer or the user of the TOPRO TAURUS walking aid should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Guidance and manufacturer's declaration
Electromagnetic IMMUNITY for all ME EQUIPMENT and ME SYSTEMS
The TOPRO TAURUS is intended for use in the electromagnetic environment specified below.
The customer or the user of the TOPRO TAURUS should assure that it is used in such an environment.
IMMUNITY test IEC 60601 test level
Electrostatic ± 6 kV contact
discharge (ESD) ± 8 kV air
IEC 61000-4-2
Electrical fast ± 2 kV for power supply lines
transient/burst ± 1 kV for input/output lines
IEC 61000-4-4
Surge ± 1 kV line(s) to line(s)
IEC 61000-4-5 ± 2 kV line(s) to earth
Voltage dips, short <5 % UT
interruptions and (>95 % dip in UT)
voltage variations for 0,5 cycle
on power supply 40 % UT
input lines (60 % dip in UT)
IEC 61000-4-11 for 5 cycles
70 % UT
(30 % dip in UT)
for 25 cycles
<5 % UT
(>95 % dip in UT)
for 5 s
Power frequency 3 A/m
(50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE: UT is the a.c. mains voltage prior to application of the test level.
TAURUS E
Input frequency: 50–60Hz
No load Output voltage: 41.0V
Maximum Output current: 900mA
Maximum Power rating: 66VA
Mean Power rating: 20VA
Working ambient temperature for actuator: −5 °C to +40 °C
Working ambient temperature for controller and battery
charger: +5 °C to +40 °C
Humidity: 15–70 %
Transport and storing ambient temperature for actuator,
controller and battery charger: −20 °C to +50 °C
Humidity: 20–80 %
Compliance
Group 1
Class B
Complies
Complies
Compliance level Electromagnetic environment – guidance
www.topromobility.com
Electromagnetic environment – guidance
The TOPRO TAURUS walking aid uses RF energy only for
its internal function. Therefore, its RF emissions are very
low and are not likely to cause any interference in nearby
electronic equipment.
The TOPRO TAURUS walking aid is suitable for use in all
establishments, including domestic establishments and
those directly connected to the public low voltage power
supply network that supplies buildings used for domestic
purposes.
Floors should be wood, concrete or ceramic tile. If
floors are covered with synthetic material, the relati-
ve humidity should be at least 30 %.
Main power quality should be that of a typical
commercial or hospital environment.
Main power quality should be that of a typical
commercial or hospital environment.
Main power quality should be that of a typical
commercial or hospital environment. If the user of
the TOPRO TAURUS requires continued operation
during power mains interruptions, it is recommen-
ded that the TOPRO TAURUS be powered from an
uninterruptible power supply or a battery.
Power frequency magnetic fields should be at le-
vels characteristic of a typical location in a typical
commercial or hospital environment.
EN
17