Roland MC-505 Replacement Manual page 15

Roland MC-505 LCD Replacement Guide
Fig. 20- New hole drilled for a third screw
Step 8:
After you have modified the case so that the new LCD fits and aligns
properly, then screw the LCD in place using two screws as shown in Fig. 19.
You should notice that two of holes do not align with the new LCD.
If you want to further secure the LCD in place you will need to drill another
hole or two. Personally, I only drill one new hole in the bottom right corner,
I have found this is sufficient to secure and align the new LCD properly in
place.
The drill bit size needed is 1/16" and these small bits tend to break easy so
go easy on it and don't put too much pressure down on the bit or it will
snap. Since the hole is unthreaded it will be harder to screw in initially, but
will still work.
15
produced by: glitchscience.com
2012©