FLIR Extech Instruments BR50 User Manual

Video borescope and cctv tester

User's Guide

Video Borescope and CCTV Tester

Model BR50

Table of Contents

Need help?

Do you have a question about the Extech Instruments BR50 and is the answer not in the manual?

Page 1 User's Guide Video Borescope and CCTV Tester Model BR50...
Page 2 Introduction Congratulations on your purchase of the Extech BR50 Video Borescope. This instrument was designed for use as a remote inspection device and a CCTV camera alignment/inspection tool. Typical applications include HVAC inspection, automotive inspection, and cable routing. The BR50 is also useful for automotive, boat, and aircraft inspection.
Page 3 Meter Description Camera connection jack External AV input jack LCD Display Status LED Power / Brightness button Charging cable connector Flexible Gooseneck Camera connection plug Camera and LED lights 10. System reset button (rear view) 11. Four (4) housing screws (rear view) BR50-EU-EN-V1.0 5/11...
Page 4 Operation Power the Meter Power Switch: Press and hold the Power button and the display will illuminate if the internal battery is charged. Press and hold the Power button again to switch off the Video Borescope. Charging the Battery: Before charging, make sure the meter is switched off. Connect the smaller end of the charging cable to the meter.
Page 5 Operating Temperature 32°F ~ 122°F (0°C ~ 50°C) Relative Humidity 85% max. Copyright © 2011 Extech Instruments Corporation (a FLIR company) All rights reserved including the right of reproduction in whole or in part in any form. www.extech.com more infor for...