Weider 9940 User Manual page 18

43. Wrap the Press Cable (72) around a 3 1/2" Pulley
(24) in the direction shown. Attach the Pulley and a
Cable Trap (25) to the indicated hole on the far side
of the Leg Press Lever (83) with a 3/8" x 4 3/4" Bolt
(60) and a 3/8" Nylon Jamnut (63). Note: Thread the
Jamnut only two turns onto the Bolt; you will later
attach another Pulley to the Bolt. Make sure the
Cable Trap is oriented as shown.
44. Wrap the Press Cable (72) around a "V"-Pulley (27)
in the direction shown. Attach the "V"-Pulley and a
Large Cable Trap (32) underneath the Press Seat
Frame (7) with a 3/8" x 4 1/4" Bolt (85), a 3/8" Flat
Washer (48), and a 3/8" Nylon Locknut (50). Note:
the Press Seat Frame has five adjustment holes.
Mount the "V"-Pulley in the hole closest to the
Leg Press Lever. Make sure the Cable Trap is ori-
ented as shown.
45. Wrap the Press Cable (72) around a 3 1/2" Pulley
(24) in the direction shown. Attach the Pulley and a
Cable Trap (25) to the near side of the Leg Press
Lever (83). Use the 3/8" x 4 3/4" Bolt (60) that was
inserted in step 43 and secure the Pulley with the
3/8" Nylon Jamnut (63). Make sure the Cable Trap
is oriented as shown.
46. Wrap the Press Cable (72) around a 3 1/2" Pulley
(24) in the direction shown. Attach the Pulley and a
Cable Trap (25) to near side of the Press Upright (2).
Use the 3/8" x 4 3/4" Bolt (60) that was inserted in
step 42 and secure the Pulley with the 3/8" Nylon
Jamnut (63). Make sure the Cable Trap is oriented
as shown.
Wrap the Press Cable (72) around a 3 1/2" Pulley
(24) in the direction shown. Attach the Pulley and a
Cable Trap (25) to the 3/8" x 4" Carriage Bolt (102)
that was inserted into the Press Base (6) earlier.
Secure the Pulley with the 3/8" Nylon Locknut (50).
Make sure the Cable Trap is oriented as shown.
43
72
60
24
25
83
44
48
27
72
45
83
60
25
46
2
18
63
7
85
32
50
24
8
72
63
50
25
60
24
24
25
102
72
63