Weider 9940 User Manual page 12

21. Remove both 3 1/2" Pulleys (24) from the pre-assem-
bled Small Pulley Bracket (22).
Wrap the Butterfly Cable (73) around a 3 1/2" Pulley
(24) in the direction shown. Attach the Pulley to the
Small Pulley Bracket (22) with a 3/8" x 1 3/4" Bolt
(57) and a 3/8" Nylon Locknut (50). Make sure the
Small Pulley Bracket is oriented exactly as
shown.
22. Wrap the Butterfly Cable (73) around a "V"-Pulley
(27) in the direction shown. Attach the "V"-Pulley and
a Large Cable Trap (32) to the bracket on the back
of the Butterfly Upright (1) with a 3/8" x 2 1/2" Bolt
(53) and a 3/8" Nylon Locknut (50). Make sure the
Large Cable Trap is oriented as shown.
23. Attach the Butterfly Cable (73) to the bracket on the
Right Butterfly Arm (11) with a 3/8" x 1" Bolt (84) and
two 3/8" Nylon Jamnuts (63). Note: The loop on the
Cable and the two Nylon Jamnuts must be mount-
ed underneath the welded bracket.
24. Identify the Ab Cable (74). It is approximately 224"
long, and it has a ball on one end and a threaded
shaft on the other. You will start by attaching the end
of the Cable with the ball.
Wrap the Ab Cable (74) around a 3 1/2" Pulley (24) in
the direction shown. Place two Pulley Covers (47)
over the Pulley, so that the slots in the Pulley Covers
are placed over the Cable. Attach the Pulley and
Pulley Covers to the indicated hole in the Butterfly
Upright (1) with a 3/8" x 3 3/4" Bolt (59), two 3/8" Flat
Washers (48), and a 3/8" Nylon Jamnut (63). Make
sure the Cable is between the Pulley and the
welded pin on the Upright.
21
57
22
53
27
73
32
23
63
11
24
59
48
Pin
74
1
12
73
24
50
22
Bracket
50
1
84
Bracket
73
47
24
63
48