Error Messages - Epson SpectroProofer Setup And Maintenance

Note:
If the SpectroProofer isn't
operating correctly, check
the Backing Color setting
in the printer's menus. If
Gray is displayed, unplug
the SpectroProofer, clean it
(see page 19), and re-seat
the cables.
Message
SP Connection Error
See manual and reconnect
cables of SpectroProofer
Mounter to printer.
SProofer Disconnected
SpectroProofer Mounter is
not recognized.
Continue?
ILS30EP Error
See manual and reconnect
ILS30EP to SpectroProofer
Mounter.
Turn printer off and on
again.
ILS30EP Disconnected
ILS30EP is not recognized.
Continue?
SpectroProofer Error
Error No. 01

Error Messages

If a problem occurs with the SpectroProofer, you may see a message on the
printer's LCD screen. Check the following list for an explanation and
instructions for solving the problem:
Explanation
The SpectroProofer is not
connected correctly.
The spectrophotometer is not
connected correctly.
The SpectroProofer is not
installed correctly
The SpectroProofer is not
connected to the printer
correctly.
The SpectroProofer is not
connected correctly.
Maintenance and Problem Solving
Solution
Turn off the printer and make sure the
SpectroProofer is connected correctly. Wait
a moment, then turn on the printer again.
Reconnect the cables and select No to turn
off the printer. Wait a moment, then turn on
the printer again. If you do not want to use
the SpectroProofer, select Yes.
Turn off the printer and make sure the
SpectroProofer is connected correctly. Wait
a moment, then turn on the printer again.
Reconnect the cables and select No to turn
off the printer. Wait a moment, then turn on
the printer again. If you do not want to use
the SpectroProofer, select Yes.
Turn the printer off and check to make sure
the SpectroProofer is connected correctly.
Turn the printer back on. If the error appears
again, contact Epson as described on
page 25.
23
| 23