Advertisement
Assembly / Operating Instructions
Attaching front and rear frames with plastic clips
1.
Insert front frame with plastic clips as per
image shown. Insert two assembly bolts.
2. Secure using plastic assembly tool.
Do not tighten completely.
Repeat for opposite end.
3. Insert rear frame into both end panels.
Using the same method as used for front frame assembly.
Assembling bath support frame
1. Insert bath frame support leg onto bath frame tube.
2.
Ensure pop pins lock into hole.
3. Secure top support tubes as shown in image using 2 x
44mm bolts either end. Repeat for bottom support tube
using the remaining 2 x 44mm bolts.
Use a phillips head screwdriver (not supplied) to secure all
4 bolts.
8
Assembly / Operating Instructions
Assembling plastic components
1. Place the three storage containers into position on the
upper rails of the front and rear frames, creating a shelf
in the centre of the unit.
2. Place the left component of the front tray into position,
then place the right component ensuring it clips into the
left component as shown. Ensure the front tray rests
against the bar on the top frame.
3. Place bathtub into position as shown.
4. Loosen top bolts on one end panel and place elastic
loops of mesh bag around bolts. Retighten bolts.
9
Advertisement
