Safety Information - Bosch ComfortElectronic RDE 1821415 Installation And Operating Instructions Manual

Safety information

This appliance is intended for domestic
use or for household-based, non-com-
mercial applications. Household-based
applications include, e.g. usage in employ-
ees catering facilities for shops, offices,
agricultural and other commercial opera-
tions, as well as usage by guests of guest
houses, small hotels and similar residen-
tial establishments.
Install and operate the appliance as
described in the text and illustrations.
We do not accept liability for damage
resulting from failure to heed these
instructions.
This appliance is intended for use up to
an altitude of 2000 m above sea level.
The appliance may only be installed and
stored in a frost-free room (due to re-
sidual water).
Risk of electric shock!
Switch off the mains voltage supply
immediately if a fault occurs.
Immediately shut off the cold water
supply to the appliance should it leak.
The continuous-flow heater may only
be connected and put into operation
by a qualified professional.
In order to avoid potential sources of
danger, repairs and maintenance may
only be undertaken by a suitably quali-
fied specialist.
Never open the appliance without dis -
connecting the power supply beforehand.
The statutory regulations of the respec-
tive country, as well as those of the local
electricity and water suppliers, must be
adhered to.
The continuous-flow heater is a Class I
appliance and must be connected to the
protective earth.
The appliance must be permanently
connected to installed pipes. The con-
ductor cross-section must comply with
the installed appliance power.
Caution: Earthed water pipes may give
the appearance of a connected protec-
tive earth.
Robert Bosch Hausgeräte GmbH
To guarantee compliance to relevant
safety regulations, an all-pole separator
must be fitted during installation. The
contact opening must be at least 3 mm.
The continuous-flow heater is only suit-
able for closed (pressurised) operation.
The tap and outlet fittings must be
approved for operation with closed
(pressurised) continuous-flow heater
systems.
The continuous-flow heater can be
operated with cold or pre-warmed water
(for example, from a solar energy unit
water supply). Observe the technical
data and the special accessories for this
purpose.
The continuous-flow heater is suitable
for connection to DVGW-tested plastic
pipes.
Disconnect the electrical connection
cable from the supply and shut off the
water supply before connecting the
appliance!
Connect the water supply and then
connect the electrical supply.
Only make the openings which are re-
quired for installation on the rear of the
appliance. If the appliance is reinstalled,
the unused openings must be provided
with watertight sealing.
Do not touch electrically live parts after
installation.
The appliance should be disconnected
from the electrical mains supply when
working on the water supply. After ser-
vice work is complete, proceed as dur-
ing the first-time appliance start-up.
No changes may be made to the
appliance.
The appliance may only be used for heat-
ing drinking water for household use.
This appliance can be used by children
aged 8 years and older as well as by per-
sons with diminished bodily, sensory or
mental perception, or those who lack
knowledge or experience, if they are
monitored or have received instruction
concerning use and comprehend the pos-
English | 9
9 001 042 048 | (15.6.15)