Table of Contents
Advertisement
The configuration consists of three stages, i.e. in the first place you configure the connection
between the cash register and the reader (pairing), next you configure the reader itself,
entering the prefix and suffix. The wary to configure is following:
1. Establishing the connection between the cash register and the barcode reader
For the cash register to be able to work with the reader, you should first configure the reader
according to its manufacturer's recommendations. To do so, first you set the SPP mode
(master) using the code to be found in the manufacturer's instruction. Next you enter the
cash register's own address into the reader. The address is to be found in the cash register
under function O
A
in the bluetooth settings. Own Address of the cash register is
WN
DDRESS
entered into the reader using the codes to be found in the reader's instruction manual. At the
end, you enter the PIN code (by default 12345678). Having entered the PIN code, automatic
pairing of the reader with the cash register takes place. The reader should be located close
to the cash register, the pairing process will be completed successfully then. It is possible to
additionally secure the cash register. In order to do so, in the function R
A
you
EMOTE
DDRESS
need to enter the address of the barcode reader to the cash register.
After the function is selected, a screen will appear that makes it possible to enter the
physical address of the device with which you want to define the exclusive communication.
Setting the barcode reader.
2. Setting the prefix in the reader – 01h
3. Setting the prefix in the reader – 0Ah
7 Sealing the cash register
The housing of the cash register is sealed with a leaden seal. The seal is a service seal and
it has the manufacture's or servicing party's identifier imprinted on it. Each fact of unsealing
and sealing of the cash register should be noted in the service book of the cash register.
The right to interfere with the interior of the cash register is reserved only to an authorized
serviceman having a valid service ID card, entered in the cash register's book or having an
appropriate authorization and being registered at the appropriate Tax Office. After each
service interference that requires taking the seal off, the user should check on his/her own
interest if the cash register has been sealed back again properly.
Note: Disturbance of the service seal is a threat for the user to loose his/her right to warranty repairs.
8 Maintenance and carrying out periodic inspection
During its operation life, the cash register requires periodic cleaning, inspection and
maintenance. All maintenance activities should be carried out with the cash register switched
off.
All external components of the cash register's housing are made of plastic and they require
periodic cleaning. The best way to do so is with a special antistatic fluid for cleaning
computer equipment (the usage according to the fluid's manufacturer recommendations).
You may also use a soft cloth, slightly moistened with water with some delicate fluid
cleansers added.
Among the maintenance activities, that are in the scope of the user's responsibility, is the
inspection of the printing mechanism and cleaning small paper residues from it. This should be
done after each 60 rolls of paper. You can most easily remove the impurities and paper dust
with the help of a small brush and compressed air. You can use a rubber bulb or compressed
98
Advertisement
Table of Contents
