Table of Contents
Advertisement
Fehler! Verwenden Sie die Registerkarte 'Start', um Titolo 1 dem Text zuzuweisen, der hier
7.7 – Every 250 Hours of Operation or Annually
Danger: Before lubricating or performing maintenance on any part of the corn head, engage the
feeder house lift cylinder safety stops, set the parking brake, turn off the combine engine and
remove the key and hang a warning sign on the operator's platform. Failure to do so could
result in serious injury or death.
Important: Because the corn head uses full synthetic oils it is not required to change these fluids. It is
only required to add oil to maintain the correct levels.
20hr Service
Perform a 20hr Service. See section 7.5.
100hr Service
Perform a 100hr Service if doing end of season
maintenance. See section 7.6.
7.7.1 – 250 Hour or Annually Grease/Lubricate
Gathering Chain Lubrication
Danger: Never lubricate gathering chains
with the corn head, base unit components,
or combine engine running.
Important: When operating in down corn do
not lubricate the gathering chains to avoid dirt
ingress into the chain.
Every 250 hours, or annually, lubricate the gathering
chains (A). It is recommended to run the chains for a few
minutes before lubricating to aid in oil penetration
between the internal pivot pins and bushings.
Lubricant Type:
SAE 30W Motor Oil
angezeigt werden soll.
Page | 85
Advertisement
Table of Contents
