Fluid Type - GE DigitalFlow DF868 Startup Manual

2.6.8 Fluid Type

[F1]-[F4]
10. Use the and [ keys to select the Fluid Type. The selections for fluid type vary, depending on whether:
• ENERGY OPTION
the
• TRACKING WINDOW
the
ENERGY OPTION
Refer to Table 10 if
Note: Some of the fluid types may require additional selections as shown in the following tables.
NO Additional Selections
WATER Select
NORML
If is selected, enter the Water
NORML
Temperature and press
OIL Select
LUBE
METH No additional selections required.
ETH Enter the Fluid Soundspeed and press
[ENT].
No additional selections required.
LN2
FREON No additional selections required.
OTHER Enter the Fluid Soundspeed and press
[ENT].
NO Additional Selections
WATER Enter the Water Temperature and press
[ENT].
MIXED Enter the Fluid Soundspeed and press
Then enter the Percentage of
[ENT].
Water and press
OTHER Enter the Fluid Soundspeed and press
.
[ENT]
DigitalFlow™ Multipurpose Ultrasonic Liquid Flowmeter Startup Guide (1- and 2-Channel)
ON OFF
is or ; and
is enabled or disabled.
OFF
is , or to Table 11 on page 27 if
Table 10: Fluid Types for ENERGY OFF
or and press
SEA [ENT]
.
[ENT]
or and press
CRUDE [ENT].
Table 11: Fluid Types for ENERGY ON
[ENT].
ENERGY OPTION
Tracking Windows =
YES
. W100 No additional selections required.
W260 No additional selections required.
OIL No additional selections required.
OTHER Enter the Minimum Soundspeed and press
[ENT].
and press
Tracking Windows =
YES
W260 No additional selections required.
MIXED Enter the Percentage of Water and press
OTHER Enter the Minimum Soundspeed and press
[ENT].
and press
ON
is .
Additional Selections
Then enter the Maximum Soundspeed
[ENT]
Additional Selections
Then enter the Maximum Soundspeed
[ENT].
Chapter 2. Initial Setup
[ENT].
27