Geokon GeoNet 8900 Series Quick Start Manual page 2

SET THE CHANNEL AS FOLLOWS:
Move the channel select DIP switch (shown in the figure below) to any of the twelve valid
positions listed in Table 1 below. The setting will take effect at power-up, or after device reset.
1:
FIGURE 1: Channel Select Switches
Modbus Address and Channel 1:
1
2
3
4
5
6
7
8
9
10
11
12
TABLE 1: Channel Selection
1.2 CONFIGURE THE SUPERVISOR
1.2.1 POWER CONCERNS
When the unit is powered, a green LED on the right side of the box will flash twice after a small
delay. The LEDs will not flash again until at least one Node has joined the Network.
Note: Deployment mode starts as soon as devices are powered on or reset. For more
information on Deployment mode, see Section 3.5 in the
Note: If replacing batteries in an existing network, ensure that the network is in deployment
mode prior to removing the batteries. See Section 4.3 in the
information on battery replacement.
MODEL 8900 SERIES GEONET WIRELESS DATA HOSTING SYSTEM | QUICK START GUIDE | 2
1 2 3 4
OFF OFF OFF OFF
ON OFF OFF OFF
OFF ON OFF OFF
ON ON OFF OFF
OFF OFF ON OFF
ON OFF ON OFF
OFF ON ON OFF
ON ON ON OFF
OFF OFF OFF ON
ON OFF OFF ON
OFF ON OFF ON
ON ON OFF ON
Instruction Manual.
Instruction Manual for more