Settings; Tool Holder, Attachments - Festool DRC 18/4 Original Instructions Manual

English
2x ... capacity indicator, indicates the charg­
ing state of the battery pack (not with NiCd
and NiMH battery packs)
LED green – lit continuous­
ly: charged > 60 %
LED green – flashing slow­
ly: charged 30 % – 60 %
LED green – flashing quick­
ly: charged 0 % – 30 %
LED yellow – lit continu­
ously: battery is empty
LED red – lit continuously:
battery temperature is out­
side the permitted range.
LED red – flashing: indi­
cates a general fault, e.g.
incomplete contact, short
circuit, battery pack faulty,
etc.
6.3 Capacity indicator
The capacity display [1-13] indicates the charge
of the battery pack for approx. 2 seconds after
the button [1-12] is pressed:
Recommendation: Charge the battery pack
*
before any further use.
7

Settings

CAUTION
Risk of injury
► Only adjust the settings when the power
tool is switched off.
7.1 Changing direction of rotation [1-8]
– Switch to the left = clockwise rotation
– Switch to the right = counterclockwise rota­
tion
7.2 Changing gear
You can change gear using the gear
switch [1-6].
16
70–100%
40–70%
15–40%
< 15%
*
7.3 Adjusting the torque [1-7]
Fastening
Select the correct torque setting:
Position 1 = low torque
Position 12 = high torque
An acoustic signal sounds when the preset tor­
que is reached and the machine then switches
off. You must release and press the ON/OFF
switch [1-4] again to start the machine.
Drilling
Mark is aligned with drill symbol
torque.
8

Tool holder, attachments

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
CAUTION
Risk of injury from hot and sharp tool
► Do not use any blunt or faulty tools.
► Wear protective gloves.
Prior to initial use: apply multi-purpose
grease to the drill spindle and gearbox
neck.
8.1 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CEN­
TROTEC tool chucks.
Wear gloves when replacing!
8.2 Chuck [5]
For clamping drill bits and bits with max. shaft
di-ameter of 13 mm.
Clamp tool centrally in the chuck.
8.3 Angle attachment [6]
Drilling and screwdriving at right angle to ma­
chine (partly as an accessory).
8.4 Tool holder in the drill spindle [7]
Bits can be inserted directly into the hexagon
socket holder of the drill spindle.
= maximum