Icom OPC-2274 Instruction Manual

INSTRUCTION MANUAL
CONNECTION CABLE
CONNECTING THE OPC-2274
1
Set the repeater channel, TX output power, and other necessary settings.
(See the repeater and the VE-PG3 instruction manuals for setting details.)
2
Turn OFF both the repeater and the VE-PG3, and then connect the OPC-2274, as shown below.
VE-PG3 (Rear view)
To [TRX1] (Upper slots)
A B C
• The [TRX1] and [TRX2] ports (upper slots) accept the OPC-2274 connectors,
however, follow the example to correctly connect the repeater to ONLY the [TRX1] on the VE-PG3.
CAUTION
• Verify that both the repeater and the VE-PG3 are turned OFF when connecting or disconnecting the cable.
• Hold the connector body when connecting or disconnecting them.
When other cables are connected, you can
use needle-nose pliers to carefully insert or
remove connectors.
Needle-nose pliers Needle-nose pliers
• Never bend or pinch the cable.
• Never place a heavy object on the cable.
• Never touch the cable with wet hands.
• Always connect the cable correctly. An incorrect connection could damage the VE-PG3 and/or the repeater.
LINE2 LINE1
PHONE
Be sure to insert the
A B C
connectors top side up.
1 2 3 4
Top
Bottom
OPC-2274
Connector Connector Connector
body body body
VE-PG3 (Rear view) VE-PG3 (Rear view)
Thank you for purchasing this Icom product.
The OPC-2274
CONNECTION CABLE
repeater to the VE-PG3.
READ ALL INSTRUCTIONS carefully and completely be-
fore using the cable.
Icom's repeater
(IC-FR5000/IC-FR6000 series)
To the accessory connector
A
NEVER pull the connector by holding the
cable. This will damage the cable.
*If the cable becomes damaged, replace the
connector(s). See "REPLACING THE
CONNECTOR" on the reverse side for
replacement details.
is used to connect a