Icom OPC-2350LU Installation Manual

INSTALLATION GUIDE
DATA CABLE
opc- 2350lu
This installation guide describes the COM port confirmation steps, and the manual installation of the OPC-2350LU
USB driver. Refer to the instruction manual for system requirements details.
NOTE:
• After the automatic driver installation has been completed, confirm the driver availability and the port number.
• The displayed dialog boxes, indications or operations may slightly differ from the following instructions, de-
pending on your operating system, system settings and its service pack level.
• These instructions are based on using Microsoft
The COM port number is used to set communication
with the cloning software.
• To confirm the driver availability and the port num-
ber, log in as the administrator.
• Confirm no other applications are running.
q Right-Click the icon as shown below, and then click
"Device Manager."
• "Device Manager" is displayed.
w Click
q Right-Click
Thank you for choosing this Icom product. READ ALL
INSTRUCTIONS carefully and completely before using
this product.
®
Windows
COM PORT CONFIRMATION
w Click "Ports (COM & LPT)." Confirm "USB Serial
®
10.
Port (COM✱)" is displayed.
• In this example, the COM port number is "3."
q Click
w Confirm
NOTE:
• If the COM port number is not displayed, double-
click "Other devices."
• If the warning symbol " " with "FT232R USB
UART" is displayed, the driver may not be prop-
erly installed. In such case, install the USB driver
manually. Refer to the next page for manual USB
driver installation details.