Husqvarna 455 Rancher II Workshop Manual page 44

Repair Instructions
4
Place guide pins on the air filter holder in the
rubber grommets D. Tighten the screws E.
Tightening torque 1.5-2 Nm. See figure 48.
5
Press down the throttle valve shaft (1) and fasten
the throttle pressure rod out to its fastening as
outlined in figure 49.
6
Fasten the return hose B and secure it in its
mountings on the air filter holder and partition wall.
Attach the pressure hose A (short hose on the
short plastic plug) on the fuel pump and carburetor.
Fasten the fuel hose C to the carburetor. See
figure 50.
7
Attach the earth cable to the carburetor and intake
system as outlined in figure 51. Note! The earth
cable should be fitted at an angle of 45° to the
intake system so as not to chafe against it.
8
Assemble the air filter and cylinder cover.
44 –
English
D
E
Fig 48
Fig 49
Fig 50
45
Fig 51
D
D
E
1
2
A
B
C